Change search
Link to record
Permanent link

Direct link
Berezovsky, VladimirORCID iD
Publications (1 of 1) Show all publications
Ohlin, L., Berezovsky, V., Öberg, S., Farzaneh, A., Holmgren, A. & Grahn, M. (2016). Effect of Water on the Adsorption of Methane and Carbon Dioxide in Zeolite Na-ZSM-5 Studied Using in Situ ATR-FTIR Spectroscopy. The Journal of Physical Chemistry C, 120(51), 29144-29152
Open this publication in new window or tab >>Effect of Water on the Adsorption of Methane and Carbon Dioxide in Zeolite Na-ZSM-5 Studied Using in Situ ATR-FTIR Spectroscopy
Show others...
2016 (English)In: The Journal of Physical Chemistry C, ISSN 1932-7447, E-ISSN 1932-7455, Vol. 120, no 51, p. 29144-29152Article in journal (Refereed) Published
Abstract [en]

Methane is the main component in biogas and natural gas along with contaminants such as water and carbon dioxide. Separation of methane from these contaminants is therefore an important step in the upgrading process. Zeolite adsorbents and zeolite membranes have great potential to be cost-efficient candidates for upgrading biogas and natural gas, and in both of these applications, knowing the nature of the competitive adsorption is of great importance to further develop the properties of the zeolite materials. The binary adsorption of methane and carbon dioxide in zeolites has been studied to some extent, but the influence of water has been much less studied. In the present work, in situ ATR (attenuated total reflection)–FTIR (Fourier transform infrared) spectroscopy was used to study the adsorption of water/methane and water/carbon dioxide from binary mixtures in a high-silica Na-ZSM-5 zeolite film at various gas compositions and temperatures. Adsorbed concentrations for all species were determined from the recorded IR spectra, and the experimental values were compared to values predicted using the ideal adsorbed solution theory (IAST). At lower temperatures (35, 50, and 85 °C), the IAST was able to predict the binary adsorption of water and methane, whereas the values predicted by the IAST deviated from the experimental data at the highest temperature (120 °C). For the binary adsorption of water and carbon dioxide, the IAST could not predict the adsorption values accurately. This discrepancy was assigned to the particular adsorption behavior of water in high-silica MFI forming clusters at hydrophilic sites. However, the predicted values did follow the same trend as the experimental values. The adsorption selectivity was determined, and it was found that the H2O/CH4 adsorption selectivity was decreasing with increasing water content in the gas phase at low temperatures whereas the selectivity was increasing at higher temperatures. The H2O/CO2 adsorption selectivity was increasing with increasing water content at all temperatures.

National Category
Chemical Process Engineering Other Physics Topics
Research subject
Chemical Technology; Applied Physics
urn:nbn:se:ltu:diva-61272 (URN)10.1021/acs.jpcc.6b09224 (DOI)000391160400028 ()2-s2.0-85008428222 (Scopus ID)

Validerad; 2017; Nivå 2; 2017-01-11 (rokbeg)

Available from: 2016-12-27 Created: 2016-12-27 Last updated: 2018-07-10Bibliographically approved

Search in DiVA

Show all publications