Change search

Cite
Citation style
• apa
• harvard1
• ieee
• modern-language-association-8th-edition
• vancouver
• Other style
More styles
Language
• de-DE
• en-GB
• en-US
• fi-FI
• nn-NO
• nn-NB
• sv-SE
• Other locale
More languages
Output format
• html
• text
• asciidoc
• rtf
Motion of chips when leaving the cutting zone during chipboard plane milling
Belarusian State Technological University.
Technical University in Zvolen.
Luleå University of Technology, Department of Engineering Sciences and Mathematics, Wood Science and Engineering.ORCID iD: 0000-0002-0145-080X
Belarusian State Technological University, Department of Technology and Design of Wooden Articles, Forestry and Wood Technology Faculty.
2017 (English)In: BioResources, ISSN 1930-2126, E-ISSN 1930-2126, Vol. 13, no 1, p. 646-661Article in journal (Refereed) Published
##### Abstract [en]

Mathematical equations were established and the following regularities of the plane milling process of wood materials were analyzed: the effect of the cutting edge inclination angle on the chip exit angle, influence of the cutting edge inclination angle on the speed of chip movement along the blade and exit speed of the chips from the cutting zone, the dependence of the chip exit angle on the friction coefficients of the chips on the processed material surface and along the blade surface (the friction coefficients were determined from the results of the experimental measurements), and influence of the mill rotation frequency on the chip exit angle. The milling of the chipboards with various mill designs was performed at different cutting conditions (diameter = 7 mm to 24 mm, number of cutting elements = 1 to 3, cutting edge inclination angle = -5° to 20°, frequency of the mill rotation = 3000 min-1 to 24000 min-1, feed per tooth = 0.1 mm to 1.5 mm). The process of chip exit from the cutting zone was photographed, and the chip exit angles were measured. A comparison of the values of the chip exit angles obtained from the experiments with those from the calculations based on the developed mathematical equations showed a high convergence.

##### Place, publisher, year, edition, pages
North Carolina State University , 2017. Vol. 13, no 1, p. 646-661
##### Keywords [en]
milling, wood material, chipboard, chips, chip exit angle, cutting edge, inclination angle, friction coefficient
##### National Category
Other Mechanical Engineering
##### Research subject
Wood Science and Engineering
##### Identifiers
ISI: 000427790000047Scopus ID: 2-s2.0-85041319615OAI: oai:DiVA.org:ltu-66910DiVA, id: diva2:1163109
##### Note

Available from: 2017-12-06 Created: 2017-12-06 Last updated: 2018-08-31Bibliographically approved

#### Open Access in DiVA

No full text in DiVA

Publisher's full textScopus

#### Search in DiVA

##### By organisation
Wood Science and Engineering
BioResources
##### On the subject
Other Mechanical Engineering

doi
urn-nbn

#### Altmetric score

doi
urn-nbn
Total: 24 hits

Cite
Citation style
• apa
• harvard1
• ieee
• modern-language-association-8th-edition
• vancouver
• Other style
More styles
Language
• de-DE
• en-GB
• en-US
• fi-FI
• nn-NO
• nn-NB
• sv-SE
• Other locale
More languages
Output format
• html
• text
• asciidoc
• rtf